Home > Windows System32 > Windows Cannot Start Because A File Is Missing Or Corrupt

Windows Cannot Start Because A File Is Missing Or Corrupt

Contents

I have been looking all over the internet for a solution because I don't have the recovery disc!. After pressing R at the set up menu I get (before any password): 1: C:\WINDOWS Which windows installation would you like to log onto (to cancel, press enter)? Note that the exact error message may vary depending on how exactly the registry was corrupted. any help would be much appreciated! news

Cheers, Tom Reply Rev December 6, 2013 Oh, you wonderful human being! Once knoppix is loaded you'll see an icon of a hard drive on the desktop labeled “hard disk partition [.....]”. i've tried the "cd command" but I system is not accessible. I ran chkdsk /p command after start 1: C:\WINDOWS.

Windows32/config/system Was Corrupt Or Missing

Luckily I had ubuntu preinstalled for dual booting (I had to save some corrupt files caused by my wdtv live) and I was thinking in the right direction, maybe I should Those would be for XP. Now minimize this window.After renaming the SYSTEM file to SYSTEM.OLD, go to the rpXX folder that you minimized and RIGHT click __registry_machine_system and select “copy”.

Thank you.. There seem to be some drivers here: http://drp.su/drivers/notebook.....8&l=en Reports: · Posted 4 years ago Top raphoenix Posts: 14920 This post has been reported. Make sure to change C:\Windows to the appropriate windows_folder if it is a different location. Windows System32 Config System Missing Or Corrupt Fix Windows 7 With little to lose at this point, in the 'copied' from window, I went ahead and used the 'undo copy' and again it prompted was I sure I wanted to 'delete'

On with the article.This option works if you have a 2nd working computer running Windows 2000, XP, or 2003 and also if you have system restore enabled on the dead computer. Windows System32 Config System Missing Or Corrupt Fix Without Cd At the Recovery Console command prompt, type the following lines, pressing ENTER after you type each line: md tmp copy c:\windows\system32\config\system c:\windows\tmp\system.bak copy c:\windows\system32\config\software c:\windows\tmp\software.bak copy c:\windows\system32\config\sam c:\windows\tmp\sam.bak copy c:\windows\system32\config\security c:\windows\tmp\security.bak What else goes in there? http://ccm.net/forum/affich-22815-windows-system32-config-system-is-corrupt Then I run it as "last working configuration" during start-up… Then thank God its back to normal… 😀

When you see this message press any key. 3. http://yellowproductions.net/windows-system32/windows-could-not-start-because-the-following-file-is-missing-or-corrupt.php When “Mini Windows XP” is loaded, open Windows explorer and find the “C:\System Volume Information” folder. 2. Iv'e formatted and repaired over and over. The diagnostic tool is run from a bootable CD (Windows does not need to be working).The first two steps are done on a working computer, while the third step is to Windows System32 Config System File Missing Or Corrupt Solution

As you only have one installation on your PC you need to press the number which is relevant to your installations location. If the restore file doesnt exist in the system volume information folder, how do i proceed from there? One would think that supposedly 'copying' files from the Config folder, that before they are instead "cut", that MS would have done a better job at protecting the OS and the More about the author Because you used the registry file that the Setup program created, this registry does not know that these restore points exist and are available.

and re-name them by appending .old to the filename, so that they now look like this ....system.old software.old security.old sam.old default.old Step 3: Still in the "config" folder at C:\Windows\System32\config Re-name What Is Windows System32 I say minor because you're only going to copy part of the registry, not the whole thing. Type exit to quit Recovery Console.

Also give a try to install your hard disk as secondary (primary to the second IDE channel) to the other computer.

rename to SECURITY _REGISTRY_MACHINE_SAM ...rename to SAM _REGISTRY_USER_.DEFAULT .... It's not full of features but when you're in a jam it does a great job. Fixed my problem. Windows System32 Config System Windows 7 It's and old satellite A80 that I'm repairing for someone to play on.

When the "Welcome to Setup" screen appears, press R to start the Recovery Console. 3. Reply lakonst Apr 15, 2014 @ 10:57:24 Just Google it. Reply lakonst Nov 07, 2013 @ 11:22:57 Hello Bob. click site Anyway, hope this helps this discussion.

I might also Add I do not have the disk did download what was said above though

Reply lakonst Dec 01, 2013 @ 11:41:26 John, try this: After you replace the corrupted registry file , boot your computer in safe mode and follow this guide to scan your issue resolved thanks! You can also download the ISO image for Seatools or Drive Fitness in my signature and burn the image to a CD using IMGBurn also in my signature and boot off All the best and please come back and let us know if you learn anything new from your efforts!

Download Easy Recovery Essentials. Reply Joshua December 11, 2013 worked great and thank you for the information. Your computer will restart Report windows config problem- Sep 21, 2009 at 03:00 PM I have the problem and I want to fix it but I don't have the disk to Can I use a USB/ Flash Drive as a substitute to CD?
Help please.